🔧 PIPE BOSS

Phone rides on the grade rod. Laser set once. Every finished stick, hit the green button — it shows the next receiver move. That's the whole job.

🔒 NO-INSTALL — locked until Erik answers

Leg past the wall (DMH15 → far cleanout, ~79′ @ 1%, 119.3 → 118.5). The plan calls DMH15 a cleanout but shows a 2.8′ internal drop — impossible in a riser. The label or the mapping is wrong, and only the engineer can say which. Nothing gets built at or past DMH15. Your 214′ run ends as an unconnected stub there.

📋 COLLECTOR CALLOUTS — reference only (not runnable yet)

Endpoint mapping not yet confirmed — these become one-tap runs after the engineer signs off. Per-stick = 10′ sticks.

ANY PIPE — enter the run

Read both structures off the CAD app. Every field matters — this is what keeps a wrong invert from getting buried.

FROM structure (name on the plan, e.g. PDMH R=124.0) TO structure RUN LENGTH from the plan callout L= (feet) START INVERT (upstream, HIGH end) END INVERT (downstream, LOW end) PLAN SLOPE from the callout S= (%, e.g. 1.0)